- Track your orders
- Save your details for express checkout
OMAX MicroMAX Precision JetMachining Centre
OMICRO
OMAX Waterjet Range
06 322 1575
Specifications
| Machine Footprint* (L x W): | 3,100 mm x 2,1800 mm |
| Height **: | 2,134 mm |
| Weight (Tank Empty): | 1,724 kg |
| Operating Weight: | 2,404 kg |
| X-Y Cutting Envelope***: | 630 mm x 630 mm |
| Z-Axis Travel***: | 114 mm |
| Table Size (L x W): | 889 mm x 914 mm |
| Material Support Slats: | 102mm x 3mm Galvanised Steel |
| Max Supported Material Load: | 1950kg/m2 |
| Electrical Requirements: | 3 Phase 380-480 VAC +/- 10% 50-60 HZ |
| Noise Level: | Below 80 dB at one metre for submerged cutting |
| Speed: | 2,540 mm/min |
| Linear Positional Accuracy: | ±2.5 microns |
| Repeatability: | ±2.5 microns |
| Ballbar Circularity: | ±13 microns |
OMAX Benefits
- Small, efficient footprint for minimal floorspace utilisation.
- Very high precision with 0.1 micron linear optical encoder system.
- Highly rigid structure with low mass bridges and carriages.
- Stiff construction greatly reduces vibration and increases accuracy.
- Vibration isolation of table and gantries.
- All components have matched thermal expansion.
- Revolutionary patent-pending process for fine abrasive feed rate.
- Full enclosure with environmental controls provides quiet, safe and clean operation below 80dB.
- Advanced pressure controls for piercing delicate materials.
- No heat-affected zones or mechanical stresses.
- Standard OMAX 7/15 Mini MAXJET 5 Nozzle acquires finer precision cutting capability with a 0.007" orifice and a 0.015" mixing tube combination.
- Standard Rapid Water Level Control for cleaner, safer, and quieter submerged cutting completes most work below 80 dB.
- Machines a wide range of materials with high accuracy.
- Can machine hardened steel as easily as annealed steel.
- Easily cut non-conductive and reflective materials.
- Leaves behind a satin-smooth edge, reducing secondary operations.
- Shipped as a completely pre-assembled and factory-tested system.
- Designed and manufactured at the OMAX factory in Kent, Washington.
Drive Description
- Closed loop digital drives, Brushless servo motors, Intelli-TRAX drive technology with linear encoder in X-Axis, Precise motorised Z-Axis.
Additional Notes
- All products meet rigorous international standards and requirements.
- Accuracy Specifications are based on a water temperature of 22°C.
- OMAX reserves the right to adjust specifications without notice.
- Install according to local electrical code.
**Height of enclosure.
*** Additional accessories may reduce travel.
**** Recommended maximum orifice size. Smaller orifice sizes have a corresponding lower flow rate, Small, efficient footprint for minimal floorspace utilisation.
.jpg)
.jpg)
.jpg)